![](/images/new-backgrounds/1214389/21438919x1.webp)
Attaching the fence to the table
The rear fence (7) is slideable and attaches to the table through the two channel openings on the table. The infeed (9) and outfeed (10) fence attach to the rear fence.
1.Using a small carriage bolt, washer and large knob attach the adjustable fence bracket (8) to the left hand side of the rear fence (7). Feed the carriage bolt through the bottom of the rear fence and through the slot in the adjustable fence bracket. Place a washer over the bolt and secure using a large knob.
2.Position the router table so you are facing the rear of the table.
3.Align the rear fence (7) over the channel openings in the table. The large dust extraction port in the fence should face the rear of the table.
4.Feed the long carriage bolt from the bottom of the table and insert it through the channel opening in the table and through the hole on the right side of the fence and through the adjustable fence bracket. Secure the bolt with a flat washer and a large lock knob.
5.Feed the medium carriage bolt through the channel
opening on the left side of the table and through the opening on the left side of the fence. Secure the bolt with a flat washer and a large lock knob.
Attaching the infeed and outfeed fence
1.Place one sliding panel along the front side of the fence and align the channel openings on the panel with the holes along the front of the fence.
2.Place a small carriage bolt through each of the two openings on the front of the panel and secure each bolt with a flat washer followed by a small lock knob.
3.Repeat steps 1 and 2 to secure the second sliding panel to the fence.
Attaching the guard to the fence
The guard (13) protects the operator from the cutting edge of the router bit. A pin secures the guard to a support on the fence. The guard will move freely when it is attached properly to the fence.
1.Place the arm of the guard (13) over the support base on the fence (7).
2.Align the openings on each side of the guard arm with the openings on the support base on the fence.
3.Slide the guard pin through both sides of the guard
10