material and adjust the outfeed fence so that it supports the cut material, compensating for the removed stock.
Maintenance
Cleaning
1.Keep the tool’s air vents unclogged and clean at all times.
2.Remove dust and dirt regularly. Cleaning is best done with a rag.
3.
4.Never use caustic agents to clean plastic parts.
Caution. Do not use cleaning agents to clean the plastic parts of the router table. A mild detergent on a damp cloth is recommended. Water must never come into contact with the router table.
General inspection
Regularly check that all the fixing screws are tight. They may vibrate loose over time.
Power cord maintenance
If the supply cord needs replacing, the task must be carried out by the manufacturer, the manufacturer’s agent, or an authorised service centre in order to avoid a safety hazard.
14
