Global Machinery Company VEC158-AU instruction manual Replacing the battery pack

N O

P Q

10.Insert the replacement bulb into the reflector’s flange.

11.Put back and secure the hairpin retaining wires (fig. N).

12.Connect the white bulb power wire to the red power wire (fig. O).

13.Tighten the retaining screw on the flange (fig. P).

14.Reassemble in the reverse order.

15.Operate switch to ensure proper operation of spotlight (fig. Q).

Replacing the battery pack

The rechargeable, sealed, lead acid batteries have a life of several years, if recharged promptly after each use. When the fully charged batteries only provide about 10 minutes or less of spotlight operation, they should be replaced with new batteries.

The VEC158-AU spotlight requires two GMC Part VEC120- AUBAT batteries, one for the upper compartment, the other for the lower compartment. It is recommended that you change both of them at the same time.

WARNING: DO NOT ALLOW BARE CONNECTORS TO CONTACT EACH OTHER DANGEROUS SPARKING CAN OCCUR. NOTE WHICH WIRES ARE ON THE BATTERY TERMINALS

CAUTION: Incorrectly connected wires will not allow the spotlight to operate. Incorrect battery polarity will damage the circuits inside the spotlight. Double check battery polarity before reassembly!

12