Unpacking
Due to modern mass production techniques, it is unlikely that your GMC Power Tool is faulty or that a part is missing. If you find anything wrong, do not operate the tool until the parts have been replaced or the fault has been rectified. Failure to do so could result in serious personal injury.
Operation
It is recommended that for first time charging, you charge your spotlight using the AC power adaptor.
Important. For first time operation of spotlight, the average charge time is 25 hours.
Charge time after first use is 25 hours.
If unit is not used for two months, it is suggested the battery be recharged for approx 4 hours and repeated every 2 months of non use.
Important. Do not charge with AC and DC chargers at the same time.
AC Power Charging
CAUTION. Use only with AC Charging Adapters that are approved with unit.
Important. Before plugging in the power supply from the charger to the spotlight always ensure that the plug is switched off at the main as well as the spotlight and trigger switch is in the off position.
1.Connect the power supply from the charger to the spotlight via the barrel connecter (14) .Plug into the recharge port socket at the back of the housing (8).
2.Plug in the charger and switch on. The LED indicator (12) will show power and that charging is taking place.
Charge for approximately 25 hours maximum, or until LED Indicator displays green when the LED status display switch is pressed.
Do not overcharge
3.Turn off the charger power supply from the main. Disconnect the barrel connecter from the recharge port (8). Wait 5 minutes before use. Store adaptor in a safe place (14).
Important. Do not operate when charging.
DC Power Charging & Corded Operation
CAUTION. Use only with DC Charging Adapters that are approved with unit.
Important. The DC source (jump starter, battery pack, vehicle accessory socket, etc.) must be 12 Volt DC. The DC source should be able to supply at least 15 amps of current if the spotlight is to be operated while the battery is being charged.
IMPORTANT. DO NOT TURN ON ANY LAMPS OR OPERATE ANY DC APPLIANCES THROUGH THE SPOTLIGHT’S ACCESSORY OUTLET WHEN THE AC/DC RECHARGE ADAPTER IS CHARGING THE UNIT.
1.Plug the DC fused recharge adapter (15) into the recharge port at the back of the housing (9).
2.Insert the power plug into the accessory socket of your power source.
3.The spotlight maybe operated whilst the internal batteries are charging.
4.Charge for approximately
5.Disconnect charger from power supply. Unplug the connecter from the recharge port (9) Wait 5 minutes before use. Store adaptor in a safe place (15).
Note. Some vehicles must have the ignition switch on to power the vehicle accessory outlet.
9
