Replacing the DC plug fuse
The fuse in the DC plug protects the charging circuit of the DC Recharge Adapter (15). If the AC recharger operates but the DC charging adapter does not, then the fuse may need replacement. To replace the fuse:
1.Unscrew the end cap of the DC Plug (counterclockwise) (fig. R).
2. Remove spring centre contact and fuse.
3.Check fuse with a continuity checker.
4. If blown, locate replacement | R |
fuse with same type and rating (15 Amp)
5.Replace the fuse, spring, contact and end cap (fig. S).
6.Screw end cap clockwise until it is finger tight-
DO NOT OVER-TIGHTEN
7. Check for proper operation | S |
of DC Charger Adapter. |
|
|
Maintenance
Store the spotlight, instruction manual and where necessary the accessories in the original packaging. In this way you will always have all the information and parts ready to hand.
Do not throw used batteries into fire or water. There is a danger of explosion! Please hand in
Important All batteries lose charge over time, especially when they are warm. AC recharge is recommended every two months, when not in frequent use. Use the AC recharger and charge for the recommended time.
If the unit has dirt on it, gently clean the outer surfaces of the spotlight unit with a soft cloth moistened with a mild solution of water and detergent. Periodically inspect the condition of recharge adapters, connectors, and wires. Replace any components that may have become worn or broken.
13