Globe SP30P, SP80PL, SP25, SP60P, SP40P, SP10 Installation, Unpacking, Connecting To Electrical Power

Installation

UNPACKING

Unpack the mixer immediately after receipt. If the machine is found to be damaged, save the packaging material and contact the carrier within fifteen (15) days of delivery. Immediately contact your source of the equipment.

You have no recourse to damage after fifteen (15) days.

TO AVOID SERIOUS PERSONAL INJURY:

•ALWAYS install equipment in work area with adequate light and space.

•ONLY operate the mixer on a solid, LEVEL, non-skid surface that is nonflammable.

•NEVER bypass, alter, or modify this equipment in any way from its original condition. Doing so my create hazards and will void warranty.

•NEVER operate the mixer without all warnings attached to it.

•DO NOT attempt to lift the mixer alone.

INSTALLATION

1.Read this manual thoroughly before installation and operation. DO NOT proceed with installation and operation if you have any questions or do not understand anything in this manual. Contact your local representative or Globe first.

2.Remove the corrugated box from the skid by removing the bands on the box. NOTE: The SP62P and SP80PL are shipped in a wooden crate. Only the bolts at the bottom of the crate (all four sides) need to be removed.

3.Carefully unbolt the mixer from the skid using a 11/16” or 3/4” wrench.

4.Select a location for the mixer keeping these points in mind:

•Floor or counter must be level.

•Easy access for maintenance and service.

•Clearance for operating controls, installing and removing agitators, bowl, or attachments.

•Sufficient space for adding ingredients during mixing periods.

•Ensure rear ventilation outlet of mixer is not blocked.

5.Use at least two other people to tilt the unit and install the rubber feet.

6.A bolt down template and bolts are available for the SP10, SP20, or SP25. Contact Globe if this is needed.

7.Inspect the mixer to ensure all parts have been provided (i.e. bowl, beater, whip, and dough hook). The SP62P only has a bowl and dough hook.

8.Read the electrical information found on the data plate located at the rear of the machine. The incoming power should match the rating on the data plate.

CONNECTING TO ELECTRICAL POWER

Cord Connected Units: This machine is provided with a three-prong grounding plug. The outlet that this plug is connected to must be properly grounded. If the receptacle is not the proper grounding type contact an electrician. Do not under any circumstances cut or remove the third ground prong from the power cord or use any adapter plug. Never use an extension cord. Low amp supply could damage the mixer or cause a fire.

Page 6