WARNINGS
SAFETY
The flurocyl must be installed by a competent person, who is responsible for adhering to
the existing standards and regulations.
ALTERATIONS
Under no circumstances should you ever attempt to make alterations to these
components or any other part of the system
SEALED COMPONENTS
Under no circumstances must the user interfere with or adjust sealed parts.
Important Information
Installation and Use Regulations
In your own interests and that of safety, it is the LAW that this product is installed by a competent person in accordance with the current issue of these regulations.
Control of Substances Hazardous to Health
Under Section 6 of The Health and Safety at Work Act 1974, we are required to provide information on substances hazardous to health.
The adhesives and sealants used in this product are cured and give no known hazard in this state.
Manual Handling
With regards to the “Manual Handling Operations, 1992 Regulations”, the appliance exceeds the recommended weight for a one man lift.
Electrical Supply
The product MUST be earthed.
All system components shall be of an approved type and all wiring to current I.E.E. wiring regulations.
External wiring must be correctly earthed, polarised and in accordance with the relevant standards.
In GB, this is BS 7671.
In IE, this is the current edition of ETCI rules.
The product MUST be connected to a permanent 230V ac, 50Hz supply.
Connection of the whole electrical system of the product, including any heating controls, to the electrical supply MUST be through one common isolator and must be fused 3 Amp maximum.
Isolation should be by a double pole switched fused spur box, with a minimum gap of 3mm for both poles. The fused spur box should be readily accessible and preferably adjacent to the product. It should be identified as to its use.
Alternatively connection can be made through an unswitched shuttered socket and 3A fused
Wiring to the product must be PVC 85°C insulated cable, not less than 0.75mm2 (24/0.20mm).
Testing and Certification
This product is tested and certificated for safety and
performance. It is, therefore, important that no alteration is made to the product, without permission, in writing, by Glow- worm.
Any alteration not approved by
the certification, warranty and may also infringe the current
issue of the statutory requirements.
CE Mark
The CE mark on the Fluropro solar control indicates that it complies with the basic requirements of the applicable directives as stated on the data badge.
