GN Netcom E2555 user manual Wall mounting, Belt clip & optional headset

Getting Started

Wall mounting

The speakerphone base can be installed on any standard wall-phone outlet as shown below. Choose a location away from electronic equipment, such as personal comput- ers, television sets or microwave ovens. Avoid excessive heat, cold, dust or moisture.

Connect cords as shown, then press	Clip wall-mount bracket
and slide down firmly so base is held	securely into notches on
securely on outlet mounting pegs	underside of base

Plug short telephone line cord into telephone jack

Plug power cord transformer into electrical outlet

Place handset in base to charge for 8 hours before first use.

Rotate antenna to fully upright position

Getting Started

Belt clip & optional headset

Install belt clip as shown below if desired.

For hands-free telephone conversations, you can use any industry standard 2.5 mm headset (purchased separately). For best results use an AT&T 2.5 mm headset.

Snap belt clip into notches on side of handset. Rotate and pull to remove.

Plug 2.5 mm headset into jack on side of handset (beneath small rubber cap)

8 9