GN Netcom GN8110 manual GN 8110 USB Set Up, System Requirements, Connect the GN 8110 USB to your

GN 8110 USB Set Up

System Requirements		Connect the GN 8110 USB to your
The GN8110-USB requires the following operating systems:		Computer - Windows 98 SE and 2000
• Windows 98 SE (Second Edition)		Turn on your computer and let it complete the boot-up process.
• Windows 2000
		Make sure that you are not running any applications.
• Windows ME (Millennium Edition)
• Macintosh OS 9.0.4 or greater.		Plug the USB connector	from the GN8110-USB into any
You must have an available USB port. The GN8110-USB does
		available USB port on the computer. Your headset does not need
not work with earlier releases of these operating systems.
		to be plugged in at this time. The first time Windows detects that
For the latest information on compatibility and use of this		the device is connected, it recognizes that there is new hardware
		required and automatically launches the Add New Hardware
product, go to the GN Netcom USB informational site at
		Wizard.
www.gnnetcom.com/usb.
General		The Add New Hardware Wizard will launch three (3) times,
		installing the following drivers:
For Windows ME or Macintosh OS 9.0.4: You do not need to		• USB Composite Device (INF\USB\INF)
install any software. Simply plug the USB connector	into	• USB Human Interface Device (INF\HIDDEV.INF)
any USB port on the computer.		• USB Audio Device (INF\WDMA_USB.INF)
For Windows 98 SE and Windows 2000: To use the GN8110-		These drivers are typically pre-loaded in Windows. No additional
USB the first time, you need to install the USB drivers necessary		software is needed. If you upgraded your system to Windows 98
for the computer to recognize the device.		SE or Windows ME, you may need to use the upgrade disk during
		this installation.