Golden Technologies GP600 SS Operation/Diagnostics, For Compass Units with the Shark Controller

Compass Onwer’s Manual – Models GP600 SS, GP600 CC, GP601SS, GP601 CC Revised 060208

OPERATION/DIAGNOSTICS

For Compass Units with the SHARK Controller

Flash codes indicate the nature of an abnormal condition directly from the SHARK Information Gauge. Without the use of any servicing tools, the condition can be simply diagnosed.

Flash	Description
Code
1	User Fault	Possible stall timeout or user error. Release
		the joystick to neutral and try again.
2	Battery Fault	Check the batteries and cabling. Try charging
		the batteries. Batteries may require replacing.
3	Right Motor Fault	Check the right motor, connections and
		cabling.
4	Left motor fault	Check the left motor, connections and
		cabling.
5	Right park brake fault	Check the right park brake, connections and
		cabling.
6	Left park brake fault	Check the left park brake, connections and
		cabling.
7	SHARK Control Unit Fault	Check the SHARK Communications Bus con-
		nections and wiring. Replace the Control Unit
8	SHARK Power Module	Check SHARK connections and wiring.
	Fault	Replace the Power Module.
9	SHARK Communications	Check SHARK connections and wiring.
	Fault	Replace the SHARK Control Unit.
10	Unknown Fault	Check all connections and wiring. Consult a
		service agent.

The SHARK modules are not user serviceable. Do not attempt to repair Shark modules.

Note that joystick OONAPU (Out Of Neutral At Power Up) is not a fault. Simply by removing your hand from the joystick and allowing it to return to the neutral position, the fault will immediately clear. If the condition persists after removing your hand, the joystick may be damaged. Consult a Service agent.

25