Gold's Gym CWTL05607 manual Not Connected PROPERLY, the CON, Sole MAY be Damaged When

5. Attach two Base Pads (82) to the Base (108)	5
with two #8 x 1" Tek Screws (83) as shown.
Insert the other Extension Leg (89) into the	82	108
Base (108) as shown. Hold two Extension Leg
Nuts (67) in the bottom of the Extension Leg.			65
Next, insert two 5/16" x 2 1/4" Bolts (65) into the
			82
top of the Extension Leg, and firmly tighten the
Bolts into the Extension Leg Nuts.
	83
		67
			89
6. With the help of a second person, carefully raise	6
the Right Upright (107) and the Left Upright (not
shown) to a vertical position.
Have the second person hold the console as-		Console
		Assembly
sembly near the Right Upright (107) as shown.
Look under the console assembly and locate
the Console Wire (66).
Connect the Upright Wire (77) to the Console			66
Wire (66). See the inset drawing. The connec-		Wire
			77
tors should slide together easily and snap
		Tie
into place. If they do not, turn one connector	66
and try again. IF THE CONNECTORS ARE
NOT CONNECTED PROPERLY, THE CON-	77		107
SOLE MAY BE DAMAGED WHEN THE
POWER IS TURNED ON. Remove the wire tie
from the Upright Wire.
7. Insert the Upright Wire (77) and the Console	7
Wire (66) into the Right Upright (107).
	Console
Set the console assembly on the Uprights (84,	Assembly
107). Be careful not to pinch the wires. While
a second person holds the console assembly,
attach it with four 5/16" x 1" Bolts (64) and four
5/16" Star Washers (8); start all four Bolts and
then firmly tighten them.
		77, 66
Plug in the power cord as described on page
11, and turn on the power as described on page		8
13. (Note: The treadmill may automatically rise		64	8
to the maximum incline level and then return to
the minimum level.) Adjust the incline to the low-		107	64
est incline level as described in step 4 on page			84
14.
	8