ASSEMBLY
Make Assembly Easier
Everything in this manual is designed to ensure that the weight bench can be assembled suc- cessfully by almost anyone. However, the weight bench has many parts and the assembly process will take time. Set aside plenty of time so that assembly will go smoothly.
Before beginning assembly, carefully read the fol- lowing information and instructions:
•To hire an authorized service technician to assemble the weight bench, call
•Tighten all parts as you assemble them, unless instructed to do otherwise.
•As you assemble the weight bench, make sure all parts are oriented as shown in the drawings.
•For help identifying small parts, use the PART IDENTIFICATION CHART on page 5.
•Assembly requires the following tools (not included):
two adjustable wrenches
one rubber mallet
one standard screwdriver
•Assembly requires two persons.
•Because of its size, the weight bench should be assembled in the location where it will be used. Make sure that there is enough clearance to walk around the weight bench as you assemble it.
•Place all parts in a cleared area and remove the packing materials. Do not dispose of the packing materials until assembly is completed.
one Phillips screwdriver
Assembly may be more convenient if you have a socket set, a set of
1.
Before beginning assembly, make sure that you have read and understand the information in the box above. See the PART IDENTIFICATION CHART on page 5 for help identifying small parts.
Attach the two Rear Stabilizers (5) to the Base
(4) with four M4 x 15mm Screws (20).
Insert two M8 x 70mm Carriage Bolts (26) up through the Base (4). Note: It may be helpful to place a piece of tape over the Carriage Bolts to hold them in place.
1
4
5 
| 5 |
20 | 26 |
| |
| 20 |
6
