2.Press a 70mm x 100mm Cap (34) into the top of an Upright (5) as shown in the inset drawing.
Attach the Upright (5) to the Base (1) with three M10 x 115mm Button Bolts (46) and three M10 Nylon Locknuts (66). Do not tighten the Nylon
Locknuts yet.
Repeat this step with the other Upright (not shown) and the Storage Base (not shown).
3.Orient the Center Frame (4) so that the warning decals are in the positions shown on page 2.
Attach the Center Frame (4) to the indicated Upright (5) with an M10 x 95mm Button Bolt (52), two M10 x 115mm Button Bolts (46), a Large Support Plate (27), and three M10 Nylon Locknuts (66). Do not tighten the Nylon
Locknuts yet.
Attach the Center Frame (4) to the other Upright (not shown) in the same way.
2 | 34 |
| |
| 5 |
| 5 |
| 1 |
| 46 |
| 66 |
3 |
|
| 5 |
| 4 |
| 46 |
| 66 |
| 46 |
| 52 |
| 66 |
| 27 |
7
