10.Grease the outside of the barrel of an M10 x 70mm Bolt Set (59). Attach the Leg Lever (10) to the Front Leg (9) with the Bolt Set. Do not over- tighten the Bolt Set; the Leg Lever must pivot easily.
11.Insert the Long Pad Tube (28) into the Front Leg
(9).Slide two Round Pads (17) with Pad Covers
(39)onto the Long Pad Tube. Then, press two Pad Caps (38) into the Long Pad Tube.
Assemble the two Short Pad Tubes (18) to the Leg Lever (10) in the same way.
12.Attach a Long Pin (32) to a Safety Spotter (6) with an M4 x 16mm Screw (58). Next, attach a Long Pin (32) to a Weight Rest (7) with an M4 x 16mm Screw (58).
Slide the Safety Spotter (6) onto an Upright (5) as shown. Insert the Long Pin (32) into the Safety Spotter and a hole in the Upright. Next, slide the Weight Rest (7) onto the Upright. Insert the Long Pin (32) into the Weight Rest and a hole in the Upright. Make sure that the heads of the Long
Pins are on the outside of the weight bench.
Repeat this step on the other side of the weight bench. Always set both Safety Spotters
(6) and both Weight Rests (7) at the same height.
10 |
|
59 | 9 |
10 |
|
| 59 |
| Grease |
11 |
|
38 |
|
39 |
|
17 |
|
28 |
|
| 9 |
10 | 17 |
18 | 39 |
| |
| 38 |
18 |
|
12 |
|
7 | 32 |
| 58 |
6 | 32 |
| |
| 58 |
| 5 |
10
