7.Attach the Medium Pin (45) to the Seat Frame (11) with an M4 x 16mm Screw (58).
Attach the Seat (14) to the Seat Frame (11) with two M6 x 16mm Screws (61), two M6 x 35mm Screws (56) and two M6 Washers (68).
8.Orient the Backrest Frames (12) so that the indi- cated holes are closer to the tops of the Frames.
Apply some of the included grease to an M10 x 185mm Hex Bolt (63). Attach the Backrest Support (13) between the Backrest Frames (12) with the Hex Bolt and an M10 Nylon Locknut (66).
Do not overtighten the Nylon Locknut; the Backrest Support must pivot easily.
Next, attach the Backrest (29) and the Headrest (23) to the Backrest Frames (12) with six M6 x 55mm Screws (67) and six M6 Washers (68). Do not tighten the Screws yet.
9.Note: For clarity, the seat is not shown in this step.
Grease an M10 x 185mm Hex Bolt (63). Attach the Seat Frame (11) and the Backrest Frames (12) to the Seat Carriage (22) with the Hex Bolt and an M10 Nylon Locknut (66). Do not overtighten the Nylon Locknut; the Seat Frame and the Backrest Frames must pivot easily.
Insert the Medium Pin (45) through a hole in the Seat Frame (11) and the tube on the Seat Carriage (22).
See the inset drawing. Grease an M10 x 80mm Hex Bolt (24). Attach the Backrest Support (13) to the Bench Frame (3) with the Hex Bolt and an M10 Nylon Locknut (66). Do not overtighten the
Nylon Locknut; the Backrest Support must pivot easily.
See step 8. Tighten the M6 x 47mm Screws (67).
9
7 |
|
|
| 14 |
|
58 |
|
|
|
| 11 |
| 45 | 68 |
|
| |
| 61 | 56 |
8 |
| 23 |
|
| |
| 29 |
|
|
| 12 |
66 | Holes |
|
| 68 | |
|
| |
68 |
| 67 |
|
| |
|
|
|
| 67 | 13 |
|
| |
9 |
|
|
45 | 66 | 12 |
11 |
|
|
|
| Grease |
| 22 | 63 |
|
| |
| Tube |
|
|
| 66 |
|
| 13 |
|
| Grease |
|
| 24 |
|
| 3 |
