8.Insert the indicated connectors into the Right Upright (78).
Next, insert the fronts of the brackets on the Bridge (95) into the Uprights (74, 78), and then fully insert the brackets. Make sure that the plastic edges of the Bridge are inside the Uprights.
Attach the Bridge (95) with six 1/4" x 1/2" Bolts
(7) and six 1/4" Star Washers (10); start all six
Bolts before tightening any of them.
See steps 4 and 6. Tighten the four 3/8" x 4 1/2" Bolts (6).
9.Have a second person hold the console assem- bly near the Bridge (95). Connect the Bridge Wire (52) to the console assembly wire. See the inset drawing in step 7. The connectors should slide together easily and snap into place. If they do not, turn one connector and try again. IF THE CONNECTORS ARE NOT CON-
NECTED PROPERLY, THE CONSOLE MAY BE DAMAGED WHEN THE POWER IS TURNED ON.
Connect the Console Ground Wire (101) to the console assembly ground wire. Insert the wires into the console assembly.
Attach the console assembly with three 3/8" x
1 1/4" Bolts (5) and three 3/8" Star Washers (9).
Be careful not to pinch the wires.
10.Identify the Storage Latch (53). Remove the tie from the end of the tube. Make sure that the sleeve has been slid over the indicated hole and that the Latch Knob (54) is locked into the indi- cated hole. Pull on the sleeve to make sure that it is locked into place.
8 |
|
| 95 |
|
|
|
|
|
|
| |
| 10 | 7 |
|
| Connectors |
7 | Edge |
| Front | ||
|
| 7 |
| ||
|
|
|
| ||
| 74 |
|
|
| |
|
|
| 10 |
| |
|
|
|
| 7 | 78 |
|
|
|
|
| |
9 |
|
|
|
|
|
| Console |
|
|
|
|
| Assembly |
|
|
|
|
| 101 52 |
|
|
|
|
| 95 |
|
| 9 |
|
|
|
|
|
| |
|
|
|
| 5 |
|
10 |
|
|
|
|
|
|
|
| 54 |
|
|
| Tube |
| Hole |
|
|
Sleeve 
53
9
