Operating Instruction
Auto clean (Optional)
AUTO CLEAN
NOTICE
1.Whenever you press the AUTO CLEAN button, Auto Clean Function will be reserved and cancelled.
2.Auto Clean function works before and after cooling or dehumidification mode. For details, refer to the below points.
3.When the unit is started after the reservation of Auto Clean ,the Cool Start function operates and indoor Fan is started after 20 seconds.
4.When you press Start/Stop button to turn off the unit after the you have reserved Auto Clean function, the
5.If you press the AUTO CLEAN button again during the product operation , Auto Clean function will be cancelled.
❏During Auto Clean function, moistures left in indoor units after Cooling Operation or Healthy Dehumidification Operation can be removed.
❏During Auto Clean function, only Start/Stop button, Plasma button and AUTO CLEAN button are available.
Forced operation
Operation procedures when the remote control can't be used.
The operation will be started if the ON/OFF button is pressed.
If you want to stop operation,
|
|
| ON/OFF | ||
|
|
|
| button | |
|
|
|
|
|
|
| Cooling Model |
| Heat pump Model |
|
|
|
|
|
|
| |
| Room Temp. ≥ 24°C(75.2°F) | 21°C(69.8°F) ≤ Room Temp. < 24°C(75.2°F) |
| Room Temp. < 21°C(69.8°F) | |
|
|
| |||
|
|
|
|
|
|
Operating mode | Cooling | Cooling | Healthy Dehumidification |
| Heating |
|
|
|
|
|
|
Indoor FAN Speed | High | High | High |
| High |
|
|
|
|
|
|
Setting Temperature | 22°C(71.6°F) | 22°C(71.6°F) | 23°C(73.4°F) |
| 24°C(75.2°F) |
|
|
|
|
|
|
Test operation
During the TEST OPERATION, the unit operates in cooling mode at high speed fan, regardless of room temperature and resets in 18 minutes.
During test operation, if remote controller signal is received, the unit operates as remote controller sets.
If you want to use this operation, Press and hold the ON/OFF button for 3~5 seconds, then the buzzer sound 1 "beep".
If you want to stop the operation,
24Room Air Conditioner
