Goldstar MV-1525W, MV-1525B owner manual Care And Cleaning, Metal Rack, Cleaning The Grease Filters

Models: MV-1525B MV-1525W

1 32
Download 32 pages 37.01 Kb
Page 24
Image 24
CARE AND CLEANING

CARE AND CLEANING

For best performance and safety, keep the oven clean inside and outside Take special care to keep the inner door panel and the oven front frame free of food or grease buitd-up

Never use rough powder or pads. Wipe the microwave oven inside and out, including the hood bottom cover, with a soft cloth and a warm (not hot)

mild detergent solution, Then rinse and wipe dr/_ Use a chrome cleaner and _Nsh on chrome, metal and

aluminum surface& Wipe spatters immediately with a wet paper towel, especially after cooking chicken or bacon. Clean your oven weekly or more often if needed.

METAL RACK

Wash the metal rack with a mild soap and a soft or nyton scrub brush. Dry comp_etely.

Do not use abrasive scrubbers or cleaners to clean rack.

CLEANING THE GREASE FILTERS

The grease filters should be removed and cleaned often, at least once a month.

I. To remove grease fi_ters, slide each filter to the side. Pull filters downward

and push to the other side, The filter will drop ouL

3, To reinstall the filters, slide it into the side slot, then push up and toward oven center to lock.

NOTE: Do not operate the hood without the filters in place.

CHARCOAL FILTER REPLACEMENT

If your oven is vented inside, the charcoa_ filter shouid be replaced every 6 to 12 months and more often if necessary. The charcoal filter cannot be cleaned.

TO order a new charcoal filter, contact the Parts

Department at your nearest Authoriz_ Service Center.

t. Remove the two vent gritle mounting screws. (2 middle screws)

_/_,,,__;_ ....

2. Tip the grille forward, then lift it out

3. Remove old filter.

2. Soak grease filters in hot water and a mitd detergent. Rinse well and shake to dry. Do not use ammonia or place in a dishwasher. The

aluminum will darken_

4. Slide a new charcoal filter into place.

The filter should rest at the angle shown and set the clock.

5. Slide the bottom of the vent cover into place. Push the top until it snaps into place, Replace the mounting screws. Turn the power back on at the main power supply and set the clock.

-24

Page 24
Image 24
Goldstar MV-1525W, MV-1525B Care And Cleaning, Metal Rack, Cleaning The Grease Filters, Charcoal Filter Replacement