Attaching the Seat Belt
Step 1.
Thread the free end of the seat belt through the belt retainer as shown.
Step 2.
Open buckle by squeezing sides of buckle to release.
Step 3.
Thread belt through the buckle as shown. CHECK to make sure that the belt is threaded correctly by pulling on the seat belt. The belt should not slip through the buckle.
Attaching the Seat Cover—2 Options
Your swing will have EITHER a vinyl or cloth seat cover. Follow the appropriate instructions below.
Vinyl Seat Cover (on certain models):
Step 1.
Slide pocket at top of vinyl seat cover over the seat back.
Step 2.
Push both ends of the seat
belt through the slots in the vinyl cover, and pull the belt through.
If slots in vinyl are not fully open, push ends of buckle through vinyl with enough force to open the slots.
Step 3.
From the inside of the seat, press the two plastic fasteners through the holes in the vinyl cover into the holes in the plastic seat.
If holes in vinyl are not fully open, push fasteners through vinyl with enough force to open the holes.
Step 4.
Fold cover around bottom of seat.
Cloth Seat Cover (on certain models):
(No plastic fasteners are included with cloth seat cover models.)
Step 1.
Slide the pocket of the cloth cover over the top of the seat as shown.
Step 2.
Push both ends of the seat belt through the slots in the cloth cover, and pull the belt through.
Step 3.
Push the plastic clip under one side of the seat as shown. Repeat on other side.
Step 4.
Pull the fabric out at the leg openings.
7 | 8 |
