Attaching the Hanger Tubes and Seat
Step 1.
Move seat back fully forward onto seat armrests.
e
NOTE: The seat back must overlap the armrests.
| OVER | Seat back | OVER |
le | A |
| A |
A |
| A | |
|
| Armrest |
|
Step 2.
Slide hanger tubes into armrests of seat as shown.
Then insert two pin screws through seat armrests into the holes in the hanger tubes and tighten securely.
Step 3.
Insert the hanger tubes into the hubs as shown. Metal buttons should pop out and lock upon full
ginsertion.
h | CHECK that the | |
| ||
| hanger tubes are | |
ar | secure in hubs by | |
pulling firmly on | ||
| ||
| them. |
be
7
Attaching the Back Brace
Working behind the seat, snap the four pins in the ends of the plastic back brace into the holes in the hanger tubes. The word “REAR” should be facing you.
Slide adjustment wire through openings in seat back, then insert ends into back brace holes as shown.
Be sure the back brace is securely attached by pulling on it.
Attaching the Tray
Slide the tray onto the hanger tube, then push sleeve of tray all the way into the armrest of the seat.
Sleeve on tray must snap completely into the armrest.
Pull on tray to be sure it is securely attached.
Push sleeve
all the way into armrest
8
