Attaching the Seat Belt
Step 1.
Thread one end of the seat belt through the belt retainer as shown.
Step 2.
Thread both ends of seat belt through the buckles as shown.
CHECK that the belt is threaded correctly by pulling on the seat belt. The belt should not slip through the buckle.
To release, push in on front of buckle.
To Use Head Supports (on certain models)
To provide head support for a smaller child, insert the two head support pads into the pockets located in the back of the cloth seat pad.
Back of cloth seat pad
Attaching the Seat Cover
Step 1.
Slide the pocket of the seat cover over the top of the seat as shown.
Step 2.
Pull the crotch strap and both ends of the seat belt through the slots in the seat cover.
9 |
Step 3.
Push the elastic loop through the hole on one side of seat.
Step 4.
Fold cover around bottom of seat. Then fasten the hook into the elastic loop on one side as shown. Repeat on other side.
CAUTION: Be sure the seat cover at armrest does not interfere with tray latching.
Using the Tray
NOTE: If tray does not latch, check back brace to be sure the word “REAR” is away from the seat.
Step 1.
Unlatch the tray by squeezing the two latches under the tray at the same time, and lift up.
Be careful not to let the tray hit your baby when lifting or closing the tray.
Step 2.
To latch tray, push it down firmly.
Tray must be latched at all times when baby is in swing. Pull up on tray to be sure it is latched.
Reclining Back—
Four Positions
Pull adjustment wire upward and pull seat backward to recline seat. Extra pressure is required to go from the third position to full recline.
For upright position, simply lift back of seat forward.
10
In
S
W th in or th do
S
In th co ru ba
S
To ta sl ho pr he
S
C be
S
O ch as
S
Fa be fit
S
Cl th up
de be Al w tr th
