4 Replacement Procedures

4.10 Touch pad

3.Peel off the glass tape and disconnect the touch pad cable from the connector on the touch pad.

4.Remove the following screws and touch pad.

• M2.5⋅4B

FLAT HEAD screw

⋅2

 

 

 

 

 

 

 

 

 

M2.54B FLAT HEAD

 

 

 

 

 

 

 

Glass tape

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

M2.54B FLAT HEAD

Touch pad cable

Touch pad

Figure 4-15 Removing the touch pad

Installing the Touch pad

To install the touch pad, follow the steps below and refer to Figure 4-14 and 4-15.

1. Install the touch pad and secure it with the following screws.

• M2.5⋅4B

FLAT HEAD screw

⋅2

2.Connect the touch pad cable to the connector on the touch pad and stick the glass tape.

3.Install the touch pad assembly to the slot of the palm rest while engaging the latches.

4.Connect the touch pad cable to the connector CN3201 on the system board.

4-26

[CONFIDENTIAL]

TECRA S3 Maintenance Manual (960-532)

Page 268
Image 268
Toshiba S4 manual Replacement Procedures Touch pad, Installing the Touch pad