4.8 Slim select bay module

4 Replacement Procedures

4.8Slim select bay module

Removing the Slim select bay module

To remove the slim select bay module, follow the steps below and refer to Figure 4-8 and 4-

9.The explanation and figure shown below are the optical drive removing/installing. As for other module, the procedure is same.

CAUTION: Do not put fingers in the slim select bay module. It may cause injury.

1.Remove the following screw securing the latch and drive the removed screw into the screw hole. (The slim select bay is unlocked.)

• M2.5⋅4B FLAT HEAD screw

⋅1

2.While sliding the latch toward the arrow direction in the Figure 4-8, pull out the slim select bay module to disconnect it from the system board.

Latch

M2.54B FLAT HEAD

Slim select bay module

Figure 4-8 Removing the slim select bay module

CAUTION: When using the DVD super multi drive as the slim select bay module, the removed drive must be kept in an ultra slim bay case.

TECRA S3 Maintenance Manual (960-532)

[CONFIDENTIAL]

4-19

Page 261
Image 261
Toshiba S4 manual Slim select bay module Replacement Procedures, Removing the Slim select bay module