4.12 Switch membrane | 4 Replacement Procedures |
4.12 Switch membrane
Removing the Switch membrane
To remove the switch membrane, follow the steps below and refer to Figure
1.Remove the following screw and lift up the upper part of the right side of the switch cover to remove.
• M2.5⋅4B FLAT HEAD | x1 |
2.Peel off the insulator and disconnect the switch cable from the connector CN3260 on the system board.
3.Remove the following screw and slide the switch membrane to the right to remove.
• M2.5⋅4B FLAT HEAD | x1 |
M2.5⋅4B FLAT HEAD
Insulator
Switch cable
Switch cover
CN3260
M2.5⋅4B FLAT HEAD
Switch membrane
Figure 4-17 Removing the SW membrane
TECRA S3 Maintenance Manual | [CONFIDENTIAL] |
