4.7 Wireless LAN card

4 Replacement Procedures

4.7Wireless LAN card

Removing the Wireless LAN card

To remove the wireless LAN card, make sure the computer is in boot mode and powered off, follow the steps below and refer to Figure 4-7.

CAUTION: Do not try to remove the wireless LAN card with the computer turned on. The computer or the wireless LAN card can be damaged. Do not touch the connectors on the wireless LAN card on the computer. Debris on the connectors may cause the wireless LAN card access problems.

1. Remove the following screw securing the wireless LAN card cover.

• M2⋅4B BIND screw

⋅1

2.Slide your finger under the wireless LAN card cover and lift it up to remove.

3.Peel off the insulator and disconnect the wireless LAN antenna cables (black and white) from the wireless LAN card using an antenna coaxial cable disconnector.

4.Press two latches outward to release the wireless LAN card.

5.Disconnect the wireless LAN card from the connector on the system board.

M24B BIND

Wireless LAN card cover

Wireless LAN antenna cable (black)

Wireless LAN antenna cable (white)

Latch

Insulator

Wireless LAN card

Latch

Figure 4-7 Removing the Wireless LAN card

TECRA S3 Maintenance Manual (960-532)

[CONFIDENTIAL]

4-17

Page 259
Image 259
Toshiba S4 manual Wireless LAN card Replacement Procedures, Removing the Wireless LAN card