
3.3 Check of the RAID configuration | 3 Tests and Diagnostics |
NO DRIVE for one drive is displayed
When “NO DORIVE” is displayed and the HDD is connected to the port, follow the procedures below to check the HDD failure. When the HDD is not connected to the port, removing of the drive causes the failure. It is not necessary to repair.
(1)Install a new HDD.
When “NO DORIVE” is still displayed, It is judged that the MB or cable fails.
(2)When a new HDD is recognized, It is judged that the HDD removed is failed. Specify the reason by using the Independent Utility.
TOSHIBA RAID / RAID Information Display Rev xx.xx.xxxx Copyright(c) 2005 TOSHIBA CORPORATION. All Rights Reserved.
Level | Status | Capacity |
LD0 | DEGRADE | xxGB |
Write cache | : Enable | |
MBR Protection | : Disable | |
S.M.A.R.T | : Enable |
Port | Assgn Status | Size | Model | Rev |
0 | xxGB | xxxxxxx | ||
1 | NODRIVE | xxGB | xxxxxxx | |
< RAID : not OPTIMAL | > |
|
|
TECRA S3 Maintenance Manual | [CONFIDENTIAL] |