2.6 HDD Troubleshooting

2 Troubleshooting Procedures

Procedure 3 Format Check

 

The computer’s 2.5” HDD is formatted using the MS-DOS FORMAT program or the physical format program of the test program. To format the 2.5” HDD, start with Check 1 below and perform the other steps as required.

Refer to the MS-DOS Manual for the operation of MS-DOS. For the format by the test program, refer to the Chapter 3.

Check 1 Format the 2.5” HDD using MS-DOS FORMAT command. Type as FORMAT

C:/S/U. If the 2.5” HDD can not be formatted, perform Check 2.

Check 2 Using the MS-DOS FDISK command, set the 2.5” HDD partition. If the partition is not set, go to Check 3. If it is set, format the 2.5” HDD using MS-DOS FORMAT command.

Check 3 Using the Diagnostic Disk, format the 2.5” HDD with a format option (physical format). If the 2.5” HDD is formatted, set the 2.5” HDD partition using MS-DOS FDISK command. If you cannot format the 2.5” HDD using the Tests and Diagnostic program, go to Procedure 4.

TECRA S3 Maintenance Manual (960-532)

[CONFIDENTIAL]

2-43

Page 85
Image 85
Toshiba S4 manual Procedure 3 Format Check