3 Tests and Diagnostics

3.31 SETUP

10.I/O ports

This option controls settings for serial/parallel port.

NOTE: Do not assign the same interrupt request level and I/O address to the serial port and PC card.

(a)Serial

Use this option to set the COM level for the serial port.

Not used

Does not assign the serial port.

COM1

Assign the serial port specified. (Default)

COM2 to COM4 Assign the serial port specified.

(b)Parallel

This option sets the interrupt request level (IRQ) and I/O port base address for the parallel port.

When ECP is selected in “Parallel Port Mode” and an option except for Not Used is selected in “Parallel”, an option window to set DMA appears.

11.Drives I/O

This option displays the address and interrupt level for hard disk drive and select bay. It is for information only and cannot be changed.

(a)Built-in HDD

This option displays the address and interrupt level for hard disk drive. This cannot be changed.

(b)Select Bay

This option displays the address and interrupt level for select bay. This cannot be changed.

12.PCI Bus

This item displays the interrupt level for the Card Bus. It is for information only and cannot be changed.

PCI BUS = IRQ10, IRQ11

3-114

[CONFIDENTIAL]

TECRA S3 Maintenance Manual (960-532)

Page 232
Image 232
Toshiba S4 manual Not used Does not assign the serial port, Assign the serial port specified. Default