Graco 24P822 important safety instructions Screen Navigation and Editing, Initial Setup

Screen Navigation and Editing

Refer to this section if you have questions about screen navigation or about how to enter information and make selections.

All Screens

1.Use to move between screens.

2.Press to enter a screen. The first data field on the screen will highlight.

3.Use to highlight the data you wish to change.

4.Press to edit.

Drop Down Field

1.Use to highlight the correct choice from the dropdown menu.

2.Press to select.

3.Press to cancel.

Number Field

1.The first digit will be highlighted. Use to change the number.

2.Press to move to the next digit.

3.When all digits are correct, press again to accept.

4.Press to cancel.

Check Box Field

A check box field is used to enable or disable features in the software.

1.Press to toggle between and an empty box.

2.The feature is enabled if a is in the box.

Operation

Reset Field

The reset field is used for totalizers. Press to reset the field to zero.

When all data is correct, press to exit the screen.

Then use to move to a new screen, or

to move between Setup screens and Run screens.

Initial Setup

NOTE: Before creating the pump profiles in Setup Screens 1 through 4, you must set up the system parameters in Setup Screens 5 through 15, as follows.

1.Press to enter the Setup screens. Setup Screen 1 will appear.

2.Scroll to Setup Screen 5.

3.See Setup Screen 5, page 22, and select the lower used in your system.

4.Continue setting the system parameters on Setup Screen 6, page 23 through Setup Screen 15, page 29.

5.Scroll to Setup Screen 1. Establish the profiles for each pump. See Setup Screen 1, page 16 through Setup Screen 4, page 20.

3A2527D 9