Talk Feature
• Press and hold Talk Button on Parent Unit to speak to your child through the child unit. You will hear a single beep when the connection to the Nursery Unit is made
and you can speak. NOTE: The Talk icon 
is showing on the LCD screen when Talk feature is active.
NOTE: When activating the Talk feature from the Parent Unit, transmission from the child unit to the parent unit is temporarily disabled.
TroubleShooting
DO NOT ATTEMPT to modify the unit. Any modifications to the Nursery Unit and/or Parent Unit can void the operator’s authority to operate the equipment.
Most problems have a simple solution. First, check that:
•Power is turned ON for both units
•Both units are plugged in (or batteries are fresh in Nursery Unit and fully charged in Parent Unit)
•Electrical outlet works
•Volume is turned up on Parent Unit
•Parent Unit is in range of the Nursery Unit
No Sound
•Battery dead or weak — replace or use AC adapter.
•AC adapter not properly connected — check the connections.
•Nursery Unit covered or blocked — remove the obstruction.
Weak Sound
•Nursery Unit too far from baby — move closer.
•Large objects blocking the signal — try repositioning Nursery Unit.
•Volume setting too low — turn it up.
Static
•Interference from other electrical equipment — eliminate cause of static (TVs, mixers, computers, fans, fluorescent lights, light dimmers, etc.)
•Parent Unit too far from Nursery Unit — move them closer.
•Significant amount of obstructions between Parent Unit and Nursery Unit such as walls, ceilings & buildings.
Try moving the Nursery Unit to another part of the room.
•Change channel on Nursery Unit.
Shrill Sound (Feedback)
•Nursery Unit and Parent Unit too close together
—move them farther apart.
•Volume set too high — lower the volume.
Parent Unit Will Not Lock on Nursery Unit
•All of the SoundLights are illuminated and the unit beeps — Go to Pairing Parent and Nursery Unit section.
Pairing Parent Unit and Nursery Unit.
To ensure privacy, your Parent Unit is paired with your Nursery Unit at the factory. Your Parent Unit will not work with any other Nursery Unit.
If Parent Unit won’t lock onto the Nursery Unit, or you purchased a new Nursery Unit, follow the procedure below to pair the Parent Unit and Nursery Unit. If you purchased a new Parent Unit, skip Step 1. The new Parent Unit is ready to pair with your Nursery Unit.
1. Erase the Pairing from the Parent Unit.
•Turn the Parent Unit off.
•Hold the Volume Down Button on the Parent Unit while pressing the On/Off Button. Continue to hold the Volume Down Button until you hear a single beep and all of the SoundLights illuminate briefly.
•Release the Volume Down Button.
•Press and hold the Volume Down Button again.
•Within 2 seconds you will hear a beep. Release
the Volume Down Button. The temperature
display will show two 
will be showing. The Parent Unit is ready to pair with Nursery Unit.
2. Pair the Parent Unit with Nursery Unit.
•Place Nursery Unit in the same room, five (5) feet (1.5 meters) away from the Parent Unit.
•Turn on Nursery Unit using the On/Off Button on the side. The green power light should come on.
•Within a few seconds, the Parent Unit will find the Nursery Unit. The SoundLights will shut off and the Parent Unit will beep. The Parent Unit is now paired with Nursery Unit.
3.Repeat this procedure if you need to pair another Parent Unit with the Nursery Unit.
Nothing happened when I turned on the Nursery Unit. What do I do?
•First try turning the Nursery Unit off, and then on again.
•If the Parent Unit still does not pair with the Nursery Unit, press the Channel Button on the Nursery Unit, then turn the Nursery Unit off, and then on again.
6
