![](/images/new-backgrounds/1199184/19918423x1.webp)
Service
Service of the Air Operated Regulators
WARNING
To reduce the risk of serious injury whenever you are instructed to relieve pressure, always follow the Pressure Relief Procedure on page 8.
1.Shut off the pump.
2.Close the ball valve at the regulator’s air inlet. Refer to Fig. 2.
3.Release all the air and fluid pressure in the regula- tor and disconnect the air and fluid lines.
4.Remove the regulator from the system.
5.Remove the swivel union (23) and spring (40) from the regulator body.
6.Remove the ball (20), seat (16), and gasket (15). See Fig. 4.
CAUTION
Use special care when handling the hard carbide ball (20) and seat (16) to avoid damaging them.
NOTE: Gasket (15) is thin and translucent. Be sure to remove the gasket.
7.Remove the six cap screws (1) and housing (6).
8.Place diaphragm assembly in a vise, with jaws on stem housing (18). Remove the retaining screw (10), jam nut (13) and washer (17) from the stem housing (18).
9.Remove the diaphragm (22) and gasket (26).
10.Remove the spring (3), valve stem (9), and gasket
(21)from the stem housing (18).
11.Thoroughly clean and inspect all parts. Replace any parts that appear to be worn or damaged.
12.Place stem housing (18) in a vise. One at a time, place the gasket (26), diaphragm (22) – white PTFE side down toward the bottom housing, and washer (17) on the stem housing (18). Secure them with the jam nut (13). Torque the jam nut onto the stem housing to
13.Install the valve stem (9), spring (3), gasket (21), and retaining screw (10) in the stem housing (18). Make sure the tab on the valve stem (9) fits into the slot on screw (10).
14.Torque the retaining screw into the housing to
15.Install the assembled parts in the housing (6).
16.On Model 214980, tighten the air line fitting (29) into the cap (7). Torque to
17.Install the cap (7). Tighten the six cap screws (1) in the sequence shown in Fig. 4, Bottom View, and to the torque noted.
18.Install the gasket (15), valve seat (16), and ball
(20)into the housing (6).
NOTE: Seat may be turned upside down and reused.
19.Screw the swivel union (23), with the
12 307212