Installation
The agitator speed controller fits the following Graco pneumatic rotary motors:
Motor Part No.
101140
16A871
101388
111310
NOTE: Before installing, ensure that the agitator air motor has at least 5 in. (12.7 cm) of vertical clearance and 4 in. (10.2 cm) of horizontal clearance in all directions around it.
NOTE: If you are using an air line lubricator, install it in the air line upstream of the speed controller.
1.Remove the air motor top cap (A) and needle valve (B) using the
2.Install the
(21)in place of the needle valve.
3.Screw the compression nut (24) onto the flange connector (23)
3A1315A | 3 |