Power Connection, Not included with kit | Graco 3A1324B instruction

Install the Kit

Power Connection

All electrical wiring must be completed by a qualified electrician and comply with all local codes and regulations.

Enclose all cables routed in the spray booth and high traffic areas in conduit to prevent damage from paint, solvent, and traffic.

The ProMix 2KE operates with 85-250 VAC, 50/60 Hz input power, with a maximum of 2 amp current draw. The power supply circuit must be protected with a 15 amp maximum circuit breaker.

Not included with kit:

•Power supply cord compatible to your local power configuration. Wire gauge size must be 8-14 AWG.

•The input power access port is 22.4 mm (0.88 in.) in diameter. It accepts a bulkhead strain relief fitting or conduit.

1.Verify that electrical power at the main panel is shut off.

2.Connect electrical cord to the terminal block (404) as shown in FIG. 5.

3.Close the Control Box. Restore power.

4.Follow instructions in Grounding in your ProMix 2KE Operation Manual.

5.See your ProMix 2KE Operation manual for operat- ing instructions.

411

404

Line

Neutral Ground

ti16391a

FIG. 5. Terminal Block Electrical Connections

TERMINAL

BLOCK

L	N	GRND
WIRE
HARNESS
(411)			POWER
			POWER
L	N	GRND	SUPPLY

LINE POWER

FILTER

WIRE HARNESS (410)

2A1A

SWITCH

ROCKER

POWER SUPPLY

WIRE HARNESS

GRND

FIG. 6. Electrical Schematic

3A1324B

Graco 3A1324B important safety instructions Power Connection, Not included with kit

Models: 3A1324B