To Assemble the Playtray
Before assembling, check that you have all the parts listed below:
|
| Screw (4) |
Door | ||
|
|
|
Playtray
Playtray mounting hooks
Step 1.
With the playtray upside down, insert two AA batteries
(we recommend alkaline disposables) into the bottom of the playtray following the molded directions for placement.
CHECK that the batteries are put in correctly. Your playtray will not function if the batteries are put in backwards.
Step 2.
To attach the battery compartment door, line up the tabs and set the door in place as shown.
Step 3.
Close the door and tighten the attached screw to hold door closed.
Step 4.
Attach the right and left mounting hooks to the underside of the playtray with the four screws provided. The mounting hooks will only fit one way.
Step 5.
Fasten the playtray to the activity center by placing it on the front of the tray as shown and snapping the two mounting hooks onto the activity center tray. CHECK that the playtray is securely fastened to the activity center tray.
DO NOT lift this product by the playtray.
FOR SAFE BATTERY USE:
Keep the batteries out of children’s reach.
Any battery may leak battery acid if mixed with a different battery type, if inserted incorrectly (put in backwards) or if all batteries are not replaced or recharged at the same time.
Any battery may leak battery acid or explode if disposed of in fire or an attempt is made to charge a battery not intended to be recharged. Never recharge a cell of one type in a recharger made for a cell of another type.
Discard leaky batteries immediately. Leaky batteries can cause skin burns or other
personal injury. When discarding batteries, be sure to dispose of them in the proper manner, according to your state and local regulations.
Always remove batteries if the playtray is not going to be used for a month or more. Batteries left in the unit may leak and cause damage.
Recommended type
Change batteries when playtray ceases to operate satisfactorily.
Caring for the Activity Center
Make sure five friction strips under base are kept clean. Clean with water only.
To wash fabric seat, unhook the eight grommets under tray and lift seat off. Machine wash in lukewarm water on delicate setting and drip dry.
NO BLEACH.
For cleaning metal and plastic parts other than friction strips, use only household soap or detergent and warm water. NO BLEACH.
Excessive exposure to sun or heat could cause fading or warping of parts.
9 |
|
10 | |
|
|
