Touch-up Hopper Attachment, Transporting the Sprayer

Removing Material Hopper From Sprayer:

The material hopper can be removed for cleaning. To remove material hopper:

1. Loosen bottom fitting.

ti8871a

2. Lift material hopper straight up, off unit.

ti8876a

3.Plug opening on bottom of material hopper with your hand.

4.Take hopper to cleaning area.

1.Place material hopper on sprayer, aligning fitting to sprayer.

2.Hand tighten fitting.

When you have finished spraying, perform the following steps:

1.Shut off compressor. Disconnect air line from gun.

2.Drain material into a bucket until most of the texture material is out of hopper.

ti8699a

3.Fill hopper with clean water. Remove nozzle from gun and allow water to flow through and out of gun.

4.Flush until gun is clean

Shutdown and Cleanup

5. Turn power switch ON.

ti9222a

6. Open gun air valve.

ti8528a

7.Trigger gun to blow air through tip, clearing out any remaining material.

8.Remove hopper from gun and finish cleaning all components. A soft brush may be used to help loosen any dried on material from surface.

Be sure to keep air passages in needle clean and free of material.

To improve working condition for future use, after clean- ing, apply a few drops of light oil to:

•Air hose quick disconnect

•Material hose connections

•Flow adjustment on gun

The handle and hopper can be removed from the sprayer for storage or transporting.

To remove hopper from sprayer, follow the procedure described on page 13.

To remove the handle:

1.Loosen two (2) wing-nut screws on either side of handle.

2.Spread handle apart and remove.

The handle is only to be used to push or pull the sprayer.