Step 5.
Repeat steps 2 and 3 on other end of changing table.
If the short tubes have |
| |
been inserted correctly, |
| |
the changing table |
| |
should be able to |
| |
FOLD UP in the |
| |
center as shown. If you | Fold up | |
cannot fold the tubes | ||
| ||
up in the center, review |
| |
steps 2, 3, and 4. |
|
Step 6.
Place pad in changing table with vinyl side up. Pull belt straps through holes in center of pad.
Step 7.
Insert VELCRO® straps into the four slots at the corners of changing table and attach to VELCRO® on underside of changing table. This will prevent pad from moving.
Step 8.
Place changing table on Pack ’N Play as shown. You may use your changing table with or without your bassinet installed. Make sure tubes are securely
over the sides of the Pack ’N Play.
Check that the changing table is supported
by the Pack ’N Play by pushing firmly down into center of changing table.
11
To Use Accessory Bag
If your bassinet is already installed, unsnap the four snaps on the bassinet end flap from either end of Pack ’N Play.
Step 1.
Snap accessory bag onto end of Pack ’N Play with four snaps as shown.
Step 2.
Snap bassinet end flap over the accessory bag with the four snaps.
To Fold Changing Table
Step 1.
Pull up on waist belt straps to fold.
Step 2.
Ends of long tubes must point up when folded as shown.
Ends of tubes
point up
Step 3.
To carry or store your changing table with your folded Pack ’N Play, see “To Cover Your Pack ’N Play” section in these instructions.
12