At first your Pack ’N Play may be like a new pair of shoes. You may need to break it in by slightly stretching the netting and fabric. If the center does not stay down, place some weight (several books) in the center of the unit and let it stand overnight.
To Install Your Bassinet
PARTS LIST
CHECK that you have all the parts listed below
BEFORE assembling your bassinet.
No tools required.
| Bassinet |
|
Loop end | Tube (2) | Wire end |
Red spring | Tube (2) | Round end |
latch end |
|
|
The four bassinet tubes are located in storage pockets sewn into the bassinet itself.
Step 1.
Insert wire end of one tube into the round end of a tube with a red spring latch.
Repeat with other tubes.
Step 2.
Slide the assembled tubes into the tunnels on the sides of the bassinet.
Step 3.
Lift bassinet by the two tubes and lower it into the Pack ’N Play. Make sure the printed warnings on the end flap are facing up.
Step 4.
Install the end of the tube without the red spring latch by placing the loop end into the slot in the plastic corner.
Step 5.
On the other end of the tube, pull back on the red spring latch and insert the loop into the slot in the plastic corner.
The loop ends must be in the slots in the corners to secure the bassinet in the Pack ’N Play. Pull up on the tube and bassinet to ensure that the tube is in place.
Step 6.
Repeat steps 4 and 5 on the other side of the bassinet.
Step 7.
Snap both of the end flaps of the bassinet to the Pack ’N Play with the eight snaps (four on each end).
Step 8.
Cover soft side of mattress with fitted sheet (on certain models) and place the mattress in the bassinet soft side up. Push down on the mattress to secure the mattress to the VELCRO® on the bassinet.
DO NOT use your bassinet without the mattress provided by Graco.
To avoid SUFFOCATION, DO NOT use extra padding such as a water mattress, mattress, or pillows inside the bassinet. Use ONLY mattress provided by Graco.
To help prevent heat
Your bassinet is now ready to use.
6
