Step 5.
To Cover Your Pack ’N Play®
Gather your unit together.
Do not force.
If unit will not fold, look for a partially latched top rail. Squeeze the latch button to release the rail.
Step 6.
Find the bottom corner belt loop (only one). This loop is for holding unit and mattress together while carrying.
Turn unit upside down, so that wheels point up. Pull the cover over your unit. Make sure carry handle attached to Pack ’N Play mattress is lined up with zipper.
Push the plastic end of the bag over wheels and feet. Turn unit over and pull bag up to cover end. Zip together.
Wheel
Foot
Handle
Step 7.
Wrap the mattress around your unit. Fasten together the VELCRO® straps, attaching the bottom strap to the bottom corner belt loop.
Models with changing table:
Turn unit upside down, so that wheels point up. Pull the cover over your unit, making sure carry handle attached to Pack ’N Play mattress is lined up with zipper. Turn unit over.
Before pulling bag up, insert | Handle |
folded changing table into the |
|
side opposite the handle as |
|
shown. Pull bag up to cover |
|
end. Zip together. |
|
CARE AND MAINTENANCE
FROM TIME TO TIME CHECK YOUR PACK ’N PLAY for worn parts, torn material or stitching. Replace or repair the parts as needed. Use only Graco® replacement parts.
IF PACK ’N PLAY IS USED AT THE BEACH, you MUST clean sand off your Pack ’N Play, including the feet, before packing it into cover. Sand in top rail lock may damage it.
TO CLEAN PACK ’N PLAY, use only household soap or detergent and warm water.
TO WASH CARRY BAG, machine wash in lukewarm water on delicate cycle and
NO BLEACH.
17 | 18 |