Graco 9651 & 9744 manual To Set Up and Use Your Canopy, Step

To Set Up and Use Your Canopy

When properly used, the canopy provides shade for your child. However, your child may be warmer inside the playard than in a shaded area outside the playard.

To help prevent build-up of heat inside the playard and to avoid over-heating your child:

!Turn canopy mesh away from the sun. Keep entire mattress shaded from sunlight at all times.

!Keep playard well ventilated:

!Always keep the front mesh panel and one side mesh panel of the playard open.

!Never cover the canopy mesh.

!Never use the canopy with a bassinet in use.

As always, use good judgment to protect your child from exposure to heat which can lead to serious injury or death.

NEVER leave your child unattended.

ALWAYS keep your child in view.

Canopy mesh

Side mesh	Front mesh
	panel
panel

Canopy

Step 1.

Unfold the tubing and slide the three sections together to form one long tube. The elastic cord in the tubing will hold the pieces together.

Step 2.

Slide the long tube into the tunnel in the canopy until both ends stick out of the tunnel 3 or 4 inches

(7.5-10 cm). The tunnel is on the shiny side near the netting.

Step 3.

Push the tube ends into the corner brackets on the Pack ’N Play. Tube end caps will snap into place in the brackets.

The mesh side of the canopy goes on the same side of the unit as the brackets. The shiny side goes on the inside of the unit.

To remove canopy, first grasp tube firmly so that it will not spring out. Then push in on end caps to release them from brackets and pull tube ends up.

Step 4.

Pull the back corners of the canopy over the back corners of the Pack ’N Play and fasten the VELCRO® squares located on the ends of the top rail and back corners of the canopy.

Tubing

Push in, then up

374-7-99 13 14