FORWARD-FACING INSTALLATION WITH LATCH
1LATCH belt must be routed through opening in child restraint for
Belt must lay flat and not be twisted.
2Adjust car seat to upright position (see fig. a and page 25, fig. g 3ECUREERECLINE STANDAINTO 5PRIGHT 0OSITIONRBY PUSHING TABS INTO LOCK POSITION
Place
3For ease of installation, extend LATCH belt to its maximum length.
4(OOK CONNECTORSNTO VEHICLE LOWER ANCHORS
(fig. b). Pull connectors to be sure they are securely attached (fig. c).
53LIDEICHILD RESTRAINTDBACK UNTIL THE CHILD RESTRAINT IS IN CONTACTCWITH THE VEHICLE SEATHBACK
60RESSEDOWN lRMLY INNCENTER OFLCHILDIRESTRAINTNTO COMPRESS VEHICLE SEATECUSHIONLWHILESTIGHTENING
LATCH belt by pulling adjustment belt.
5SESYOUR KNEEUTO PRESS DOWN IN CENTERROF child restraint (fig. d).
70ULL FRONT TORBACK AND LEFT TO RIGHT ATABELT PATHE TO CHECK FOR SECUREFINSTALLATION (fig. e)4HE4
CHILDIRESTRAINTESHOULD NOT MOVE SIDE TOUSIDE ORN FORWARD MORE THAN INCHT CM
#HECKETHAT THE LOWER ANCHORAGE BELTWSTAYS tight and does not slip from the tightened position. If it does not stay tight, try another
SEATINGTPOSITION OROCONTACTI#USTOMER 3ERVICE
8!TTACH TETHER STRAPTHOOK (A) to anchor hardware (B) and tighten adjustment belt to
REMOVE ANY SLACK (fig. f).
Belt must lay flat and not be twisted.
0ERFORM THIS TEST EVERYYTIME YOU DRIVE WITH YOUR child.
14
