Graco PD106974A, 1758573 manual REAR-FACINGINSTALLATION with Latch

REAR-FACINGINSTALLATION WITH LATCH

1LATCH belt must be routed through opening in child restraint for rear-facingmode.

(see page 29, fig. d 

Belt must lay flat and not be twisted.

2Adjust child restraint to recline position (see fig. a and page 25, fig. g 0LACEL rear-facingONOVEHICLEESEAT EQUIPPEDSWITH

LATCH anchors.

3For ease of installation, extend LATCH belt to its maximum length.

4(OOK CONNECTORSNTO VEHICLE LOWER ANCHORS

(fig. b). Pull connectors to be sure they are securely attached to the anchor points. (fig. c).

50RESSEDOWN lRMLY INNCENTER OFLCHILDIRESTRAINT while pulling LATCH adjustment belt. (fig. d).

6

7

0ULL FRONT TORBACK AND LEFT TO RIGHT ATABELT PATHE TO CHECK FOR SECUREFINSTALLATION (fig. e) 4HE

CHILDIRESTRAINTESHOULD NOT MOVE SIDE TOUSIDE ORN FORWARD MORE THAN  INCHT CM 

#HECKETHAT THE LOWER ANCHORAGE BELTWSTAYS tight and does not slip from the tightened position. If it does not stay tight, try another

SEATINGTPOSITION OROCONTACTI#USTOMER 3ERVICE

#HECKELEVEL INDICATORLON CHILD RESTRAINT

Vehicle must BEBON LEVEL GROUNDVANDLCHILDRIN CHILDIRESTRAINTEWHEN CHECKINGTLEVELHINDICATOR

Ball MUST be entirely in green zone (fig. f). If necessary, place rolled towels under child

RESTRAINT ATIVEHICLE SEAT CREASE UNTIL ENTIREEBALL IS IN GREEN ZONEE4HEN RECHECKELEVEL4INDICATOR

DO NOT use tether rear-facing4ETHERHmustBE STOREDTSEE h4ETHERH3TORAGEv PAGER 

0ERFORM THIS TEST EVERYYTIME YOU DRIVE WITH YOUR child.

12