Graco PD156938C owner manual REAR-FACING Installation with Latch

REAR-FACING INSTALLATION WITH LATCH

1Adjust child restraint to recline position (fig. a). Flip recline feet under child restraint for rear facing use.

Make sure Forward Facing LATCH belt is stored. (see fig. c, pg. 37)

2Place rear-facingon vehicle seat equipped with LATCH anchors.

3For ease of installation, extend LATCH belt to its maximum length.

4Hook connectors to vehicle lower anchors (fig. b). Belt must lay flat and not be twisted. Pull connectors to be sure they are securely attached to the anchor points. (fig. c).

5Press down firmly in center of child restraint while pulling LATCH adjustment belt. (fig. d).

6Pull front to back and left to right at belt path to check for secure installation (fig. e).

Check that the lower anchor belt stays tight and does not slip from the tightened position. If it does not stay tight, try another seating position or contact Customer Service.

7Check level indicator on child restraint (fig. f).

Vehicle must be on level ground and child in child restraint when checking level indicator.

Ball MUST be entirely in green zone (fig. f). If necessary, place rolled towels under child restraint, at vehicle seat crease, until entire ball is in green zone. Then re-check level indicator.

DO NOT use tether rear-facing. Tether must be stored (see “Tether Storage” page 47).

Periodically check that child restraint is securely installed and properly leveled; adjust if necessary.

To remove LATCH, (see “Removing LATCH from Vehicle Anchor Points”, p. 36).