Combination Lap/Shoulder Belt with Sliding Latch Plate
Locking clip
This belt has a latch plate that slides freely along the belt.
This belt MUST be converted to prevent movement of the lap portion of the belt. You must use a locking clip (provided with the child restraint) when using the child restraint without the base unless your vehicle’s seat belt can be converted in another way as described in your vehicle owner’s manual.
To Install Locking Clip: (DO NOT use with base) | 1/2 inch | |
1. | Tighten the buckled belt by pushing down | (1 cm) |
| hard on the child restraint and pulling hard |
|
| on the shoulder belt. | |
2. | While pushing down on child restraint, pinch | |
| the two straps together behind the buckle |
|
| tongue. Unbuckle the belt | |
| without allowing it to slip. | |
3.Connect lap and shoulder belts with locking clip as shown
and .
4. Rebuckle belt. Check that lap belt does |
|
not move by pulling and |
|
pushing hard on child restraint. |
|
If belt loosens or lengthens, |
|
repeat procedure. | Locking clip goes here, |
1/2 inch (1 cm) from the buckle
18
