Operation
Connecting the Blast Hose and Air Hose
1.Make sure the inlet hose connections are tight, and that hose restraints are properly installed and secure.
2.Open the air supply valve (125 psi, 8.6 Bar, 0.86 MPa maximum). If necessary, use a regulator in the supply air line to meet these specifications.
NOTE: See air compressor manual for operation and startup information.
3.Connect the blast hose, hose restraints, control hoses, and coupler pins.
ti24706a
|
| F | RUN | |
O | F |
|
| TART |
|
|
| ||
|
|
| S |
|
NOTE: If you are using an electric blast control, check all of the electrical connections from the panel to the blast control.
NOTICE
Make sure no electrical connections will be exposed to water. Exposure to water could cause a short circuit and damage the equipment.
10 | 334666B |
