Setup |
Mixing Material |
ti3906a |
ti3907a |
CAUTION |
Do not use any | NOTE: For best results, mix | 2 Agitate to a smooth, | 3 After texture material is thor- |
materials. | material in a separate container | consistency. | oughly mixed, gently set ball |
| and pour it into hopper. |
| end of Material Thickness |
Use | 1 Slowly add one bag of texture |
| Gauge on surface of mixture. |
only. |
|
| |
| to clean water as instructed on |
|
|
Proper material mixture is | bag. |
|
|
essential. The pump will not | For best results do not use partial |
|
|
operate if material is too thick. |
|
| |
| bags. |
|
|
READY | ADD WATER |
ti2498a
NOTE: For an accurate test, be sure gauge is completely dry and clean every time it is used.
4Observe ball on the material. When the material is thin enough to spray, the ball will sink completely into the mix- ture.
5If the ball does not sink com- pletely into the mixture within 10 seconds, add more water, agitate and try again.
NOTE: Thicker materials that do not pass the Material Thickness Gauge test, can be used. Before spraying thicker materials test pump performance first. If the material is too thick you will not achieve good results.
12 | 309915D |
