Graco Inc 248083, 248082, 248084 manual Setup, Preparation, Removing & Installing Hopper

	Setup
	Setup
Preparation
	K
L
23	TI3056A
	cc
WLE	A
	ti3908a
N	dd
ti4003a

4Connect air and material hoses to gun. Tighten securely).

5Connect one end of material hose (cc) to material outlet (K or L) and the other end to gun material inlet (bb).

NOTE: Material plug must be installed in material outlet (K or L) you are not using.

6 Open gun air valve (23).

7Check engine oil level. Add SAE 10W-30 (summer) or

5W-20 (winter) oil, if neces- sary.

8Fill fuel tank (A) (Fueling, page 13).

Removing & Installing Hopper

		G
	ti3899a
	G
H		H
		ti3902a
	ti3900a	ti3925a
	Removing Hopper (G)	Installing Hopper (G)
The hopper (G) can be removed	1 Push down 2 latches on each	2 Position coupler (H) over material outlet and slide hopper (G)
from cart for cleaning and when	side of hopper coupler (H).	straight down, over the fitting as far as it will go, making sure hopper
using the Siphon Kit 248112,		bracket is positioned over cart handle rod.
available from your Graco	Lift hopper (G) straight up, off
distributor.	of unit.	Secure latches on each side by pushing them, firmly up, into locked
		position.

309915D 7