|
| Setup |
Fueling |
|
|
| E |
|
| OFF |
|
| ON |
|
| TI3037A |
|
| A |
|
|
| ti3962a |
|
| ti3908a |
Fuel Specifications | Refueling Procedure | CAUTION |
• Use automotive gasoline with a | 1 Shut OFF engine. Remove fuel | 3 Tighten fuel cap firmly. | • Close black fuel shutoff lever | |
pump octane number of 86 or | tank cover. |
| whenever you are transporting | |
higher. If engine knocks or pings, | 2 In a well ventilated area, add | Fuel vapor or spilled fuel can | sprayer to prevent fuel from | |
use a higher octane fuel. | unleaded automotive gasoline | ignite. If any fuel is spilled, | flooding engine. | |
• Unleaded fuel minimizes com- | to fuel tank. Leave 1/2 (13 mm) | make sure are is dry before | • Keep sprayer upright and level | |
at top of tank for gasoline | starting engine. | |||
bustion chamber deposits. | when operating and when trans- | |||
expansion. |
| |||
|
| porting. This prevents crankcase | ||
• If using gasohol, it may contain |
|
| ||
|
| oil from leaking into combustion | ||
no more than 5% methanol, and | NOTE: Tank capacity is 0.95 |
| ||
| chamber, which makes start up | |||
must have methanol cosolvents | gallon (3.6 liter). |
| ||
| very difficult. | |||
and corrosion inhibitors. |
|
|
| |
NOTE: The HONDA engine | Do not smoke or allow flames |
|
| |
or sparks in area where engine |
|
| ||
warranty does not cover damage |
|
| ||
is refueled or where gasoline is |
|
| ||
resulting from the use of gasoline |
|
| ||
stored. |
|
| ||
containing alcohol. |
|
| ||
|
|
|
•Do not use oil and gasoline mix- tures or contaminated gasoline.
Operation |
|
|
|
Characteristics |
|
| W |
|
| Start | |
|
|
| |
|
|
| Run |
| 23 | 7136A |
|
|
|
| |
CLOSED |
| OPEN | ti3909a |
CAUTION |
|
| CAUTION |
Always start system with | • Air bleeds from gun nozzle when | Before pulling engine starter rope | Allow engine to cool a minimum |
compressor air relieved. See | gun valve (23) is open. Close air | (R), pressure unloader valve (W) | of 10 minutes or use an |
Pressure Relief Procedure, | valve (23) to stop air when prim- | must be moved up to START | insulating glove, before |
page 6. | ing system. See System Adjust- | position. Move valve down to RUN | disconnecting air lines or |
| ment, page 17, for more gun | position after motor has started. | attempting to restart. |
| characteristics. |
|
|
309915D | 13 |
