CONFIGURATION GUIDE
CONFIGURING HT496 THROUGH VOICE PROMPT
DHCP MODE
Select voice menu option 01 to enable HT496 to use DHCP.
STATIC IP MODE
Select voice menu option 01 to enable HT496 to use STATIC IP mode, then use option 02, 03, 04, 05 to set up IP address, Subnet Mask, Gateway and DNS server respectively.
FIRMWARE SERVER IP ADDRESS
Select voice menu option 13 to configure the IP address of the firmware server.
CONFIGURATION SERVER IP ADDRESS
Select voice menu option 14 to configure the IP address of the configuration server.
UPGRADE PROTOCOL
Select voice menu option 15 to choose firmware and configuration upgrade protocol. User can choose between TFTP and HTTP.
FIRMWARE UPGRADE MODE
Select voice menu option 17 to choose firmware upgrade mode among the following three options: 1) always check, 2) check when pre/suffix changes, and 3) never upgrade.
WAN PORT WEB ACCESS
Select voice menu option 12 to enable WAN Port Wed Access of the device configuration pages.
Grandstream Networks, Inc. | HT496 User Manual | Page 15 of 29 |
| Firmware 1.0.3.86 | Last Updated: 7/2007 |