SERVICE MISCELLANEOUS
B
A
C
J
F
L 
G
I 
H
E
D
MX9224
3.Remove cap (A), cotter pin (B), castle nut (C), caster yoke and wheel assembly (D) and caster bushing (E).
NOTE: It is not necessary to remove the bearing races
(F) and (G), unless the bearings need to be replaced.
4.Remove seal (H) and lower bearing (I).
5.Remove upper bearing (J).
6.Clean and inspect bearings (I) and (J); pack with clean grease. Replace bearings if needed.
7.Install lower bearing (I) and a new seal (H).
8.Install upper bearing (J).
NOTE: Do not overtighten castle nut (C). Tighten castle nut only enough to remove excess play from bearings. Align crossdrill and nut to allow installation of the cotter pin (B). The caster wheel yoke assembly must be free to rotate.
9.Install caster bushing (E) on yoke shaft, and install caster yoke and wheel assembly (D), castle nut (C), and cotter pin (B).
10.Apply grease to lubrication fitting (L) until you can see grease at the top bearing (J). Install grease cap (A).
Service Miscellaneous - 27
