Installation
NOTE: If you have a Back Supply Plenum (BSP), this must
be installed before the hood.Fig. 1 Please see Page 10.
For Wall/Single Island Style |
|
|
|
|
|
|
|
|
Hoods, prior to installation, |
|
|
|
|
|
|
|
|
check with local authorities |
|
|
|
|
|
|
| Bottom |
having jurisdiction on clearances |
|
|
|
|
|
|
| |
to combustible surfaces, etc. |
|
|
|
|
|
|
|
|
With the hood still inside its |
|
|
|
|
|
|
|
|
packing crate, position the unit |
|
|
|
|
|
|
|
|
beneath its installation location. | Pallet | |||||||
Carefully remove the packing |
|
|
|
|
|
|
| Protective Material |
|
|
|
|
|
|
| ||
crate. Place some protective |
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
| |
material on the floor next to
the crate to avoid damaging the hood as it is tipped on its side; Fig. 1. Tip the hood carefully onto the protective material. If you have filler panels, install them now; Fig. 2. If you have integral filler panels, no additional installation is needed.
Hood Installation Overview
If a Back Supply Plenum is provided, install first. Before raising hood, insert 1/2 in. (12.7 mm) diameter threaded rod (by others) into hanger brackets on hood top. Check the engineering drawings or UL label located on the inside of the hood for proper hood height above finished floor. Install filler panels if needed. Raise and hang hood from adequate roof or ceiling supports All hanger brackets must be used and the hood must be properly supported while lifting to prevent damage or distortion to the hood. The hood must be hung level to operate properly. After hood is secured, make the exhaust duct connections. The fire system distributor must be contacted at this time. After the fire system has been installed, mount the enclosures, then the supply plenums. If an Horizontal Supply Plenum is provided, it should be installed before the enclosures. The hood and accessories are now installed. Finally, make the electrical connections from switches to fans and complete the fire system circuits as required by the job specification.
Filler Panel Installation Instructions
1.Uncrate the hood and lay it on the floor with protective material between the hood and the floor. (Fig. 1)
2.Bolt the filler panels together with 5/16 in. bolts provided in the hardware package.
3.Position the filler panels to the hood back, and
4.To allow for ease of cleaning, caulk the external seams with NSF Approved silicone caulk (GE SCS1009, or its equivalent). The caulk is not provided.
5/16 IN. X 3/4 IN. BOLTS WITH WASHERS & NUTS
HOOD
HOOD
HOOD
RIGHT FILLER PANEL
BOTTOM FILLER PANEL
Fig. 2
5 Canopy Hood
®
